Cerbero Sealer for Concrete and Microcement

£75.00

Cerbero Sealer for concrete and microcement is a transparent polyurethane finish for cementitious overlays such as Ercole® and Microbond®. It is colourless and it’s made of not-yellowing resins. Combined with Cerbero Base made up a resistant and protective film to increase the resistance of the coating preserving it from abrasions and scratch, resistant to grease, acid and alkaline substances.

3 in stock (can be backordered)

EAN: N/A SKU: Cerbero_Sealer Categories: , Tags: , ,
Ecobeton

Description

Cerbero Sealer for concrete is a transparent polyurethane finish for cementitious overlays such as Ercole® and Microbond®. It is colourless and it's made of not-yellowing resins. Combined with Cerbero Base made up a resistant and protective film to increase the resistance of the coating preserving it from abrasions and scratch, resistant to grease, acid and alkaline substances.

Properties od Cerbero Sealer for concrete and microcement

• Two-component polyurethane water-based finish
• Roller, T-bar or airless pump application
• Internal use (private and public)
• High resistance to water, grease and chemical compound
• UV stable, non-yellowing
• Anti-scratch
• Resistant from abrasions

Cerbero Sealer is used as a superficial finish to protect low thickness cementitious overlays such as Ercole® and Microbond®. Cerbero Sealer is recommended in a residential and public building like offices, shops, medical clinic, etc. Avoid use onto vehicle accessible surfaces.

Application of Cerbero Sealer

Make sure the surface is perfectly hardened, structurally sound, dry and previously treated with Cerbero Base (read the related technical datasheet). Before applying the first coat be sure that the surface is clean and free from dirt.
Stir the bottles before use. In a clean bucket, mix carefully Part A with Part B (catalysis ratio 5:1) for 2 minutes. The workability time of the product is around 2 hours; it may vary depending on the environmental conditions (temperature and moisture).
Proceed to apply
Cerbero Sealer using a short nap roller, T-bar or airless pump. Do not exceed the application and avoid puddles on the surface.
If you want to reach an optimal result apply two coats of Cerbero Base and one coat of
Cerbero Sealer.
It is possible to dilute
Cerbero Sealer with 10% of water to make the application easier in specific environmental condition (warm weather, windy, etc.)
Cerbero Sealer must be applied on a dry surface after 2-3 hours and within 8 hours after Cerbero Base. If this time is not observed, is necessary sand the surface with 220/320-grain sandpaper before the application. The curing time of Cerbero system (Base and Sealer) is 72 hours, at 25°C and 65% RH.

Brand

Ecobaton

Italian manufacturer of concrete additives, concrete rapir systems and concrete protection. Also microcements and cementitious overlays
Ecobeton

Additional information

Weight 2 kg
Dimensions 10 × 20 × 25 cm

No Comments Yet.

Leave a reply